AEG F99009W0P - Manual (Page 24)

Problem Possible cause Possible solution
Dry water drop stains on
glasses and dishes.
The rinse aid quantity is too
low.
Increase the rinse aid quantity.
The detergent can be the
cause.
Use a different brand of deter-
gent.
The dishes are wet. The washing programme was
without a drying phase or with
a decreased drying phase.
For better drying results, keep
the door ajar for some minutes.
The dishes are wet and matt. The rinse aid dispenser is emp-
ty.
Fill the rinse aid dispenser with
rinse aid.
The multitab function is on
(this function automatically
deactivates the rinse aid dis-
penser).
Activate the rinse aid dispenser.
Activating the rinse aid dispenser
1. Open the menu option.
2. Go to Settings .
3. Press the OK touchpad to open the submenu.
4. Go to Rinse aid and activate the rinse aid dispenser.
5. Press the OK touchpad.
6. Press the return touchpad to close the menu option.
TECHNICAL DATA
Dimensions Width 596 mm
Height 850 mm
Depth 625 mm
Water supply pressure Minimum 0,5 bar (0,05 MPa)
Maximum 8 bar (0,8 MPa)
Water supply 1) Cold water or hot water maximum 60 °C
Capacity Place settings 12
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
The rating plate on the inner edge of the appliance door shows the electrical connection
data.
If the hot water comes from alternative sources of energy, (e.g. solar panels, photovoltaic
panels and aeolian), use a hot water supply to decrease energy consumption.
24 Technical data