AEG F99009W0P - Manual (Page 22)

If the holes in the spray arms become clogged, remove remaining parts of soil with a thin
pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads or solvents (acetone).
WHAT TO DO IF…
The start of the appliance does not occur or it stops during operation.
Try to find a solution to the problem. Refer to the indications in the table.
With some malfunctions, the display shows a message and an intermittent acoustic sig-
nal operates.
WARNING!
Deactivate the appliance before you do the checks.
Malfunction Possible cause Possible solution
The appliance does not fill with
water.
The water tap is blocked or
there is limescale on it.
Clean the water tap.
The water pressure is too low. Contact your local water au-
thority.
The water tap is closed. Open the water tap.
The filter in the water inlet
hose is blocked.
Clean the filter.
The connection of the water
inlet hose is not correct.
Make sure that the connection
is correct.
The water inlet hose is dam-
aged.
Make sure that the water inlet
hose has no damages.
The appliance does not drain
the water.
There is a blockage in the sink
spigot.
Clean the sink spigot.
The connection of the water
drain hose is not correct.
Make sure that the connection
is correct.
The water drain hose is dam-
aged.
Make sure that the water drain
hose has no damages.
The anti-flood device operates. Close the water tap and con-
tact the service centre.
The start of the washing pro-
gramme does not occur.
The appliance door is open. A
message shows in the display.
Close the appliance door.
You did not press the start
touchpad.
Press the start touchpad.
The mains plug is not connec-
ted in the mains socket.
Connect the mains plug.
22 What to do if…