AEG SKS71200F0 - Manual (Page 13)

WHAT TO DO IF…
During operation of the appliance some smaller but annoying trouble can often occur,
which does not require calling a technician out. In the following chart information is given
about them to avoid unnecessary charges on service.
The operation of the appliance goes with certain sounds (compressor and circulating
sound). This not means a trouble, but a normal operation.
The appliance operates discontinuously, so the stopping of compressor does not mean be-
ing no current. That is why you must not touch the electrical parts of the appliance before
breaking the circuit.
Problem Possible cause Solution
The compressor operates
continually
The Temperature regulator may
be set incorrectly
Set a warmer temperature
The door does not close tightly
or it is not shut properly
Check if the doors close well and
the gaskets are undamaged and
clean
The door has been opened too
frequently
Do not leave the door open longer
than necessary
Food placed in the appliance was
too warm
Allow food to cool to room tem-
perature before storing
The temperature of the room
that contains the appliance is
too high for efficient operation
Try to reduce the temperature in
the room where the appliance
stands
The sound level in the
cabinet is too high
The pipes, at the back of the
cabinet, touch each other
Carefully bend them
Water flows at the back
plate of the refrigerator
During automatic defrosting,
frost melts on the back plate
It is normal
Water flows into the re-
frigerator compartment
The outlet can be clogged up Clean the outlet
Products placed in can prevent
water from flowing into the col-
lector
Replace the products so that they
can not touch the back plate di-
rectly
Water flows onto the
floor
The melting water outlet flows
not into the evaporative tray
above the compressor
Put the melting water outlet to
the evaporative tray
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the lamp".
It is too warm in the re-
frigerator
The Temperature regulator may
be set incorrectly
Set a lower temperature
What to do if… 13