AEG FAVORIT 99015 VI - Manual (Page 20)

TROUBLESHOOTING
The appliance does not start or it stops
during operation.
First try to find a solution to the prob-
lem (refer to the table). If not, contact
the Service. With some problems, the display
shows a message and the Time Beam
shows an alarm code.
Display Time Beam Problem
OPEN THE TAP The appliance does not
fill with water.
DRAIN BLOCKED The appliance does not
drain the water.
SERVICE CODE The anti-flood device is
on.
WARNING!
Deactivate the appliance before
you make the checks.
Problem Possible cause Possible solution
The programme
does not start. The mains plug is not con-
nected in the mains socket. Connect the mains plug.
The appliance door is open.
The display shows the mes-
sage PLEASE CLOSE
DOOR . Close the appliance door.
You did not press OK
START. Press OK START.
The fuse in the fuse box is
damaged. Replace the fuse.
The delay start is set. Cancel the delay start or
wait for the end of the
countdown.
The appliance does
not fill with water. The water tap is closed. Open the water tap.
The water pressure is too
low. Contact your local water au-
thority.
The water tap is clogged or
there is limescale on it. Clean the water tap.
The filter in the water inlet
hose is clogged. Clean the filter.
The water inlet hose has a
kink or a bend. Make sure that the position
of the hose is correct.
The anti-flood device is on.
There are water leakages in
the appliance. Close the water tap and
contact the Service.
20