AEG Voxtel C115 - Manual (Page 10)

9
tPress the OK button to confirm.
>The third digit of the code will be blinking.
tPress the up or down button to set the third digit of the remote access code.
tPress the OK button to confirm the new remote access code setting.
the stop button to return to standby mode.
8.8 TAM HD on/off setting
Two different compression rates (on and off) are provided for you to select the recording quality / total
recording time of incoming messages. With the compression rate set to on the recording quality will
be higher, but it will only save up to about 20 minutes of messages. With the compression rate set to
off the recording quality will be lower, but it will save up to about 40 minutes of messages.
tPress the menu button
.
>The display shows “OPTIONS MENU“.
tPress the up or down button until de display shows “TAM HD: ON” (or “TAM HD: OFF”).
tPress the OK button to confirm.
>The “ON“ (or “OFF“) will be blinking.
tPress the up or down button to select “ON“ or “OFF“.
tPress the OK button to confirm the TAM HD setting.
9 TELEPHONE OPERATION
9.1 Ringer volume
The ringer high / low switch located at the back of the base unit, allows you to adjust the volume of
the ringer.
High volume
Low volume
9.2 To make a call
tLift the handset or press the speakerphone button on the base unit.
>Check for dial tone.
tDial the telephone number.
>The display shows the duration of the call in minutes and seconds.
OR Using pre-dialling:
tDial the telephone number.
>If you make a mistake you can correct it by using the delete button to delete digits and then
adding the right ones.
tLift the handset or press the speakerphone button on the base unit to dial out the number.
9.3 To answer a call
tWhen the phone rings, lift the handset or press the speakerphone button on the base unit.
>The display shows the duration of the call in minutes and seconds.
9.4 To adjust the speakerphone volume
tDuring a call, adjust the volume of the speakerphone to your comfortable volume level using the
volume buttons located on the top of the base unit.
>The display shows the volume level from 1 to 6 in the lower left corner of the LCD screen.
9.5 To end a call
>Replace the handset on the base unit cradle or press the speakerphone button on the base unit.