AEG SWD81800G1 - Manual (Page 15)

Problem Possible cause Solution
Water flows on the
ground. The melting water outlet
does not flow in the evap-
orative tray above the
compressor. Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low. The temperature regulator
is not set correctly. Set a higher temperature.
The temperature in
the appliance is too
high. The temperature regulator
is not set correctly. Set a lower temperature.
The door is not closed cor-
rectly. Refer to "Closing the
door".
Many bottles are stored at
the same time. Store less bottles at the
same time.
There is no cold air circula-
tion in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
dEMo appears on the
Display. The appliance is in dem-
onstration mode (dEMo) Keep pressed approximate-
ly 10sec the Alarm button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly.
Upper or lower
square is shown in
the temperature Dis-
play. An error has occurred in
measuring the tempera-
ture. Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
REPLACING THE LAMP WINE
CELLAR
Disconnect the mains plug from the mains
socket.
Remove the lamp cover by pressing it in-
wards with a tool (e.g. screwdriver) to free
the rear side hookings.
ENGLISH
15