AEG L76480FL - Manual (Page 26)

1
2
9. Clean the filter under the water tap
and put it back in the pump into the
special guides.
10. Make sure that you tighten correctly
the filter to prevent leakages.
11. Put the flap back and close the drain
pump door.
THE INLET HOSE FILTER AND
THE VALVE FILTER
It could be necessary to clean the filters
when:
• The appliance does not fill with water.
• The appliance fills with the water for a
long time.
• The indicator of button 4 flashes and
the display shows the related alarm. Re-
fer to 'Troubleshooting'.
WARNING!
Disconnect the mains plug from
the mains socket.
To clean the water inlet filters:
1. Close the water tap.
2. Remove the water inlet hose from the
water tap.
3. Clean the filter in the inlet hose with a
stiff brush.
4. Remove the inlet hose behind the
appliance.
5. Clean the filter in the valve with a stiff
brush or a towel.
45°
20°
6. Install again the inlet hose. Make sure
that the couplings are tight to pre-
vent leakages.
7. Open the water tap.
EMERGENCY DRAIN
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (6) of
'To clean the drain pump'.
If necessary, clean the pump.
Put the drainage duct back and close the
drain pump flap.
26 www.aeg.com