AEG L76480FL - Manual (Page 20)

nutes or hours. The related symbols
comes on.
2. Press button 4 , the appliance starts
the countdown of the delay start.
When the countdown is completed,
the programme starts automatically.
Before you press button 4 to
start the appliance, you can cancel
or change the set of the delay
start.
You cannot set the delay start with
the Steam programme.
CANCEL THE DELAY START
1. Press button 4 . The related indica-
tor flashes.
2. Press button 5 again and again until
the display shows 0’.
3. Press button 4 . The programme
starts.
OPEN THE DOOR
While a programme or the delay start op-
erates, the appliance door is locked.
To open the appliance door:
1. Press button 4 . The door lock sym-
bol in the display goes off.
2. Open the appliance door.
3. Close the appliance door and press
button
4 . The programme or the
delay start continues.
If the temperature and level of the
water in the drum are too high,
the door lock symbol stays on and
you cannot open the door. To
open the door do the steps that
follow:
1. Deactivate the appliance.
2. Wait for some minutes.
3. Make sure that no water is in
the drum.
If you deactivate the appliance, it
is necessary to set the programme
again.
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The acoustic signals operate.
• In the display
comes on.
• The indicator of the Start/Pause button
4 goes off.
• The door lock symbol goes off.
• Press button
1 to deactivate the ap-
pliance. After five minutes from the end
of the programme, the energy saving
function automatically deactivates the
appliance.
When you activate the appliance
again, the display show the end of
the last set programme. Turn the
programme knob to set a new cy-
cle.
• Remove the laundry from the appli-
ance. Make sure that the drum is emp-
ty.
• Keep the door ajar, to prevent mildew
and odours.
• Close the water tap.
The washing programme is completed,
but there is water in the drum:
– The drum turns regularly to prevent the
creases in the laundry.
– The door stays locked.
– You must drain the water to open the
door.
To drain the water:
1. If necessary, decrease the spin speed.
2. Press the Start/Pause button 4 . The
appliance drain the water and spin.
3. When the programme is completed
and the door lock symbol goes off,
you can open the door
4. Deactivate the appliance.
The appliance drain and spin au-
tomatically after approximately 18
hours.
20 www.aeg.com