AEG X69453MD02 User Manual

Page 14

EN - INSTALLATION

FITTING THE HOOD BODY

• Open the top suction panel and fasten it to the

hood body on the left using the pin, so that it

does not close again.

• Unlock the lower suction panel by removing the

fixing pin on the left, and open it.

• Remove the Metal grease filters using the handles

provided.

• Adjust the two screws

Vr, in the brackets 11a, so

that they are at the start of their travel.

• Hook the hood body to the two brackets

11a.

• From the inside of the hood body, turn screws

to level the hood body itself.

• Fasten the safety screws

11.

• Close the suction panels.

CONNECTIONS

DUCTED VERSION AIR EXHAUST SYSTEM

When installing the ducted version, connect the hood

to the chimney using either a flexible or rigid pipe

ø 150 or 120mm, the choice of which is left to the

installer.
To install a ø 150 pipe

• To install the dumper

• Fix the pipe in position using sufficient pipe clamps

(not supplied).

To install a ø 120 pipe

• To install a ø 120 mm air exhaust connection,

insert the reducer flange

9 on the dumper 10.

• Fix the pipe in position using sufficient pipe clamps

(not supplied).

• Remove any activated charcoal filters.

RECIRCULATION VERSION AIR OUTLET

.
• Screw the filter cover onto the air outlet, using

four screws

12c (2.9 x 12.5).

• Fix the directional grille

8 on the recirculation air

outlet using the 2 screws

12d (2,9 x 9,5) pro-

vided.

ш 120

ш 150

11a

12c

12d