Troubleshooting – AEG F66682M0P User Manual

Page 36

• If you regularly use short duration

programmes, these can leave

deposits of grease and limescale

inside the appliance. To prevent this,

we recommend to run long duration

programmes at least 2 times per

month.

12. TROUBLESHOOTING

If the appliance does not start or it stops

during operation. Before you contact an

Authorised Service Centre, check if you

can solve the problem by yourself with

the help of the information in the table.

With some problems, the display

shows an alarm code.

Problem and alarm code

Possible solution

You cannot activate the ap-
pliance.

• Make sure that the mains plug is connected to the

mains socket.

• Make sure that there is no a damage fuse in the fuse

box.

The programme does not
start.

• Make sure that the appliance door is closed.
• Press Start.
• If the delay start is set, cancel the setting or wait for the

end of the countdown.

• The appliance has started the procedure to recharge

the resin inside the water softener. The duration of the
procedure is approximately 5 minutes.

The appliance does not fill
with water.
The display shows

• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not

too low. For this information, contact your local water
authority.

• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.

The appliance does not
drain the water.
The display shows

• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.

The anti-flood device is on.
The display shows

• Close the water tap and contact an Authorised Service

Centre.

Once you have checked the appliance,

deactivate and activate the appliance. If

the problem occurs again, contact an

Authorised Service Centre.

For alarm codes not described in the

table, contact an Authorised Service

Centre.