Xerox WorkCentre M118i-6288 - Manual (Page 37)

Changing the Default Time Settings
Xerox CopyCentre/WorkCentre 118 User Guide 37
Sleep Mode
The machine automatically switches to the Sleep Mode after the Low Power Mode
continues for a specified period of time. The Sleep Mode has a reduced power
consumption compared to the Low Power Mode. In this mode, the screen is turned off,
and the Power Saver light is on. The Sleep Mode is cancelled when the
button is pressed, or a fax or print job is received by the machine. The factory default
setting of 1 minute is customer changeable within the range of 1 to 239 minutes.
For more information, refer to Power Saver in the Setups chapter on page 128.
Changing the Default Time Settings
This section describes how to change the default time settings such as Auto Clear,
Power Saver, and Scanning Timer. For more information, refer to Timer Settings in the
Setups chapter on page 127.
1. Press the button on the
control panel.
2. Select [System Settings] using the
button.3.Enter the Key Operator password using
the numeric keypad on the control
panel.NOTE: The default Key Operator password is “11111”.4.Select [Confirm] using the button, or press the button.
3. Enter the Key Operator password using
the numeric keypad on the control
panel.
NOTE: The default Key Operator password is “11111”.
4. Select [Confirm] using the
5. Select [Common Settings] on the
[System Settings] screen using the
button.6.Press the button.7.Select [Timer Settings] on the [Common
Settings] screen using the
button.
6. Press the button.
7. Select [Timer Settings] on the [Common
Settings] screen using the
8. Press the button.
button