Xerox WorkCentre M118i-6288 - Manual (Page 151)

Fax Settings
Xerox CopyCentre/WorkCentre 118 User Guide 151
Specify whether or not to print two received consecutive documents as a single page.
The arrangement of the scanned documents is fixed as top to bottom.
Rotate 90°
Specify whether or not to automatically rotate the image to be received.
If the orientation of the received document and loaded paper differ, the machine
automatically rotates the image by 90 degrees.
Print Limit
Sets the start and end times for printing out incoming faxes and reports.
Documents that have been interrupted during output due to the end time are stored into
memory and can be automatically printed out at the next start time.
Select [Always On] to print out the documents at all times.
NOTE: Set days of the week together with the time. Otherwise, the machine cannot
print out the documents mentioned above.
Transfer Document
Specify how a received fax is to be processed by the machine.
• Save – Saves a received fax on the machine.
• Transfer – Forwards a received fax to a specified destination. You can select the fax
number of the destination from the Address Book. When [Enter Speed Dial] is
selected, you can specify the fax number of the destination using the One Touch
Dial button, or Speed Dial code. To complete specifying the fax number, press the
button.
• Transfer & Print – Forwards a received fax to a specified destination and prints it out
simultaneously. You can select the fax number of the destination from the Address
Book. When [Enter Speed Dial] is selected, you can specify the fax number using
the One-Touch Dial button, or Speed Dial code.
• Print – Prints out a received fax immediately.
F Code
Use this feature to configure the default settings for receiving faxes using F Codes. For
more information about F code,Refer to F Code in the Fax chapter on page 73.
After selecting from the displayed F Code list, press the button. Then select
the following items to continue the necessary settings.