System settings – Xerox WorkCentre M118i-6288 User Manual

Page 142

9 Setups

142

Xerox CopyCentre/WorkCentre 118 User Guide

WINS Server

• Get DHCP Address – Specify whether to automatically acquire or manually specify

the IP address required for using WINS from a DHCP server.

• Primary IP, Secondary IP – These items are used to confirm the automatically

acquired address or manually set address. Enter addresses in the format
xxx.xxx.xxx.xxx. Each group of 3 numbers (xxx) must be within the range of 0 to 255.
When the primary IP address is invalid, the secondary IP address is also invalid.

Ethernet Settings
Sets the communication speed/connector type of the Ethernet interface. When [Auto]
is selected, 100BASE-TX or 10BASE-T is automatically selected. Select [100BASE-
TX] when fixing Ethernet to 100BASE-TX for use. Select [10BASE-T] when fixing
Ethernet to 10BASE-T for use.

IPX/SPX Frame Type
Specify the following types for IPX/SPX frame type: [Ethernet II], [Ethernet 802.3],
[Ethernet 802.2], or [Ethernet SNAP]. When [Auto] is selected, the frame type is
automatically specified.

Filter

• IP Filter – Specify whether or not to restrict acceptance of printing by the IP address.

When [On] is selected, only printing from a registered address is accepted.

• IP Address – When restricting acceptance of printing by the IP address, register the

IP address for acceptance of printing. Up to ten IP addresses can be registered. The
registered IP address is needed to set with the IP address mask. Enter IP address
or IP mask in the format: xxx.xxx.xxx.xxx.xxx.

*1 When entering text, use the following items.

[Enter Number]: Select to enter numbers.
[Enter Alphabet]: Select to enter alphabetic characters.
[Text Input]: Select to confirm the entered text.

System Settings

Use this feature to specify the default settings for various printing reports or to set the
machine clock.

Select the required option by selecting
[T] or [S] using the