Asus Dual Pentium III Group Server AP200 - Manual (Page 9)

9
I. Introduction
AP200 Hardware Reference Guide
I. Introduction
1-4. Safeguards
Observe the following safety instructions any time you are connecting or
disconnecting any devices.
Operation Safety
Tools Required
A Phillips (cross) screwdriver and a standard (flat) screwdriver are needed
to install or remove the components in this server.
IMPORTANT
• Any operation on this server must be conducted by certified
or experienced persons.
• Before operating your server, carefully read all the manuals
included with the server package.
• Before using the server, make sure all cables are correctly
connected and the power cables are not damaged. If any dam-
age is detected, contact your dealer as soon as possible.
• To avoid short circuits, keep paper clips, screws, and staples
away from connectors, slots, sockets and circuitry.
• Before opening the chassis panels, make sure all power cables
are unplugged.
• Avoid dust, humidity, and temperature extremes. Place the
server on a stable surface.
• If the power supply is broken, do not try to fix it by yourself.
Contact an authorized dealer.
• It is recommanded that you wear gloves when assembling or
dissembling the server to protect from cuts and scrapes.
• When the server is powered on, heat sinks and the surfaces
of certain IC devices may be hot. Do not touch them. Check
whether the fans are functioning properly.
Safeguards