Using the cycle print mode, Using the cycle print mode -32 – AGFA IT SR 24 User Manual
Page 57
2-32
Sc
ann
er
Ch
apte
r 2
18. Using the Cycle Print Mode
This function automatically scans the next image following a preset period of time. Images
are manually loaded onto the Carrier Glass in between cycles.
This is a system setting that must be entered by an authorized dealer.
If you want to use the Cycle Print Mode, ask y
our Tech. Rep. to make the necessary system
setting. Then you can perform the following operations.
* This function is only available
when using the Printer mode.
Specifying the interval between scanning operations
Press the Multi-Print Key to change the value to “A”. This enables the Cycle Print
Mode. Press the Multi-Print Key to set the interval of time between scan operations.
(Refer to the diagram below).
Press the Memory Input key to store the currently selected interval setting of the Cycle
Print Mode into the memory.
Value
1
2
3
4
5
6
7
8
9
0
Period (sec.)
0.5
1.0
1.5
2.0
2.5
3.0
3.5
4.0
4.5
5.0
1
Memory Input Key
2
0820771003.book Page 32 Monday, March 19, 2001 2:49 PM