Konica Minolta bizhub PRO C6000L - Manual (Page 28)

Operation Precautions 2
2-18 bizhub PRO C6000L
2.5
2.5 Operation Precautions
To ensure the optimum performance of this machine, observe the precautions described below.
2.5.1 Power source
The power source requirements are as follows.
Use a power source with as little voltage or frequency fluctuations as possible.
2.5.2 Operating environment
The environmental requirements for correct operation of the machine are as follows.
- Operating temperature: 10°C (50°F) to 30°C (86°F)
- Humidity: 10% to 80%
2.5.3 Storage of copies
To store copies, follow the recommendation listed below.
- Copies that are to be kept for a long time should be stored where they are not exposed to light or high
temperature in order to prevent them from fading or sticking together.
- Adhesive that contains solvent (e.g., spray glue) may dissolve the toner on copies.
2.5.4 Ozone release
During print operation, a small quantity of ozone is released. This amount is not large enough to harm anyone
adversely. However, be sure the room where the machine is being used has adequate ventilation, especially
if you are printing a high volume of materials, or if the machine is being used continuously over a long period.
2.5.5 Direct sunlight
Do not install the machine and its options in a place exposed to direct sunlight, otherwise the machine per-
formance may be degraded or any trouble may be caused.
Destination North America Europe, Southeast
Asia, Australia
Voltage 208 V to 240 V AC 220 V to 240 V AC
Frequency 60 Hz 50-60 Hz