Iii. installation, 22 asus p/i-ap55tv user’s manual, Connectors) iii. inst alla tion – Asus P/I-AP55TV User Manual
Page 28
22
ASUS P/I-AP55TV User’s Manual
III. INSTALLATION
9. System Power LED (TB LED)
The motherboard's turbo function is always on. The turbo LED connection is
labeled here but the LED will remain constantly lit while the system power is
on. You may wish to connect the Power LED from the system case to this lead.
See the figure below.
10. SMI Suspend Switch Lead (SMI)
This allows the user to manually place the system into a suspend mode or "Green"
mode where system activity will be instantly decreased to save electricity and
expand the life of certain components when the system is not in use. This 2-pin
connector (see the figure below) connects to the case-mounted suspend switch.
If you do not have a switch for the connector, you may use the "Turbo Switch"
since it does not have a function. SMI is activated when it detects a short to
open moment and therefore leaving it shorted will not cause any problems. May
require one or two pushes depending on the position of the switch. Wake-up can
be controlled by settings in the BIOS but the keyboard will always allow wake-
up (the SMI lead cannot wake-up the system). If you want to use this connector,
"Suspend Switch" in the POWER MANAGEMENT SETUP of the BIOS soft-
ware should be on the default setting of Enable. See the figure below.
11. Reset Switch Lead (RESET)
This 2-pin connector connects to the case-mounted reset switch for rebooting
your computer without having to turn off your power switch This is a preferred
method of rebooting in order to prolong the life of the system's power supply.
See the figure below.
12. Keyboard Lock Switch Lead & System Power LED (KEYLOCK)
This 5-pin connector connects to the case-mounted keyboard lock switch for
locking the keyboard and also to connect the system power LED. The system
power LED lights when the system is powered on. See the figure below.
13. Speaker Connector (SPEAKER)
This 4-pin connector connects to the case-mounted speaker.
System Case Connections
GND
GND
+5V
GND
Reset SW
SMI Lead
System
Power LED
+5V
NC
GND
LOCK
GND
+5V
GND
SPKR
Speaker
Connector
GND
System
Power LED
Keyboard Lock
(Connectors)
III. INST
ALLA
TION