Konica Minolta bizhub 4050 - Manual (Page 12)

[Advanced Functions] 3-3
3.2 Operations required to use this function (for administrators) 3
3.2 Operations required to use this function (for administrators)
Select Administrator Mode - [Network] - [ThinPrint Setting] in Web Connection, then configure the following
settings.
Settings Description
[.print client Settings] Select whether or not to use the ThinPrint protocol on this machine.
Select [ON] to use this machine as ThinPrint Client (.print Client).
[Disable] is specified by default.
[Port Number] Enter the port number of ThinPrint Engine (.print Engine) to be connected.
[4000] is specified by default.
[Compressed Size] Specify the maximum packet size between 128 and 64000 to compress data
in the ThinPrint Engine (.print Engine) side (units: bytes).
ThinPrint Engine (.print Engine) compresses data in these sizes before sending
a print job to this machine.
[8192] is specified by default.
[Timeout] Enter the connection timeout value to send a print job from ThinPrint Engine
(.print Engine) between five and 300 (units: seconds).
[90] is specified by default.
[Printer Class] Enter this machine's printer class name that is used in ThinPrint Engine (.print
Engine) (using up to seven characters).
[Printer Name] Enter this machine's printer name that is used in ThinPrint Engine (.print En-
gine) (using up to 32 characters).
[Connection Service
Settings] Select whether or not to use Connection Service.
[Server Address] Enter the address of the server that supplies Connection Service.
Use one of the following formats.
•
Example of host name entry: "host.example.com"
• Example of IP address (IPv4) entry: "192.168.1.1"
[Port Number] Enter the number of the port that is used for Connection Service.
[4001] is specified by default.
[AYT Rate] Enter the reconnection interval to check Connection Service operations (units:
seconds).
[60] is specified by default.
[Client ID] Enter the client ID of this machine to be used for Connection Service.
[1] is specified by default.
[Authentication Key] Enter the authentication key used to connect to Connection Service.
[0] is specified by default.
[Connection Service
Status] Displays the status of the connection with Connection Service.
Clicking [Update] updates the status.