AEG KO-LAMAVAT 76730 - Manual (Page 47)

Installation and connection instructions
47
Water inflow
A pressure hose 1.5m in length is supplied.
If a longer inflow hose is required, only a VDE-approved, complete set
of hoses with fitted hose screw connections offered by our Customer
Service is permissible.
– Hose sets in lengths of 2.2m, 3.5m and 5m are available for washing
machines without Aqua-Control.
– Hose sets in lengths of 2.0m, 2.9m and 3.9m are available for wash-
ing machines with Aqua-Control.
Caution! Never cut into pieces in order to extend the hoses!
3 Sealing rings are supplied either in the plastic
nuts of the hose screw connection or in the enc-
losed pack. Do not use other seals!
0 1. Connect the hose with the angled connection to
the machine.
Caution!
– Do not lay the infeed hose ver-
tically downwards. Instead, turn
it to the right or left as shown
in the diagram.
– Tighten the hose connection
only by hand.
2. Connect the hose with the straight connection
to a water tap with a R 3/4 (inch) screw thread.
Caution! Only tighten the screw connection ma-
nually.
3. By slowly opening the water tap before putting
the washing machine into operation, check that
the connection is free of leaks.