Konica Minolta bizhub PRESS C8000e User Manual
Page 18
bizhub PRESS C8000
2-11
2.2
Regulation Notices
2
CE Marking (Declaration of Conformity) for Users of the European Union (EU)
This product complies with the following EU directives:
89/336/EEC, 73/23/EEC and 93/68/EEC directives.
This declaration is valid for the area of the European Union.
This device must be used with a shielded network (10 Base-T/100 Base-TX) cable and a shielded parallel ca-
ble. The use of non-shielded cables is likely to result in interference with radio communications and is pro-
hibited under CISPR rules and local rules.
USER INSTRUCTIONS FCC PART 15 - RADIO FREQUENCY DEVICES (For U.S.A. Users)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interfer-
ence to radio communications. Operation of this equipment in a residential area is likely to cause harmful in-
terference in which case the user will be required to correct the interference at his own expense.
WARNING:
The design and production of this unit conform to FCC regulations, and any changes or modifications must
be registered with the FCC and are subject to FCC control. Any changes made by the purchaser or user with-
out first contacting the manufacturer will be subject to penalty under FCC regulations.
This device must be used with a shielded network (10 Base-T/100 Base-TX) cable and a shielded parallel ca-
ble. The use of non-shielded cables is likely to result in interference with radio communications and is pro-
hibited under FCC rules.
INTERFERENCE-CAUSING EQUIPMENT STANDARD (ICES-003 ISSUE 5) (For Canada Users)
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
This device complies with Canadian RSS-Gen.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of this de-
vice.
Cet appareil est conform à la norme CNR-Gen du Canada.
L’utilisation de ce dispositif est autorisée seulement aux deux conditions suivantes : (1) il ne doit pas produire
de brouillage, et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu,
même si ce brouillage est susceptible de compromettre le fonctionnement du dispositif.
For Users in countries not subject to Class B regulations
WARNING:
This is a Class A product. In a domestic environment this product may cause radio interference in which case
the user may be required to take adequate measures.
This device must be used with a shielded network (10 Base-T/100 Base-TX) cable and a shielded parallel ca-
ble. The use of non-shielded cables is likely to result in interference with radio communications and is pro-
hibited under CISPR rules and local rules.
LED radiation safety
This product is a machine which operates by means of a LED (light emitting diodes) exposure system. There
is no possibility of danger from the LED optical radiation, because the LED optical radiation level does not
exceed the accessible radiation limit of class 1 under all conditions of operation, maintenance, service and
failure.