Asus P5GPL-X SE - Manual (Page 42)

1-30 Chapter 1: Product introduction
5. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor
or switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends
a high-level signal to this connector when a chassis component
is removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
P5GPL-X
®
P5GPL-X SE Chassis intrusion connector
CHASSIS
+5VSB_MB
Chassis Signal
GND
(Default)
Never connect a 1394 cable to the USB connectors. Doing so will
damage the motherboard!
6. USB connectors (10-1 pin USB56, USB78)
These connectors are for USB 2.0 ports. Connect the USB/GAME
module cable to any of these connectors, then install the module to a
slot opening at the back of the system chassis.
P5GPL-X
®
P5GPL-X SE USB 2.0 connectors
USB56
USB+5
V
USB_P6- USB_P6+ GN
D
NC
USB+5
V
USB_P5- USB_P5+
GN
D
1
USB78
USB+5
V
USB_P8- USB_P8+ GN
D
NC
USB+5
V
USB_P7- USB_P7+
GN
D
1
USB/Game module is purchased separately.