Alliance Laundry Systems UW35B2 - Manual (Page 3)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
© Copyright 2005, Alliance Laundry Systems LLC
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any
means without the expressed written consent of the publisher.
F232168 1
Table of
Contents
Safety Information.............................................................................. 3
Important Safety Instructions ............................................................... 3
Programming ...................................................................................... 5
Entering Program Mode ....................................................................... 5
Determining Firmware ID Code ........................................................... 5
Setup Mode (For Models With Firmware ID Code
“o2HC”, “o2UC”, “ouHC” and “ouUC”) ...................................... 6
Cycle and Error Count .......................................................................... 6
Setup Mode (For Earlier Models) .................................................... 7
Cycle and Error Count .......................................................................... 7
Programming Cycle Segments......................................................... 8
Options for Each Segment .................................................................... 9
To Edit an Entire Wash Cycle Formula................................................ 13
Wash 1 – Wash 4 ............................................................................. 13
Rinse 1 – Rinse 4 ............................................................................. 14
Abnormal Conditions............................................................................ 16
Door Open During Operation .......................................................... 16
Excessive Fill Time.......................................................................... 16
Door Will Not Open......................................................................... 16
Excessive Drain Time ...................................................................... 16
Drain Error (For Models With Firmware ID Code
“o2HC”, “o2UC”, “ouHC” and “ouUC”) ...................................... 16
Temperature Probe Sensor Problem ................................................ 16
Frame Limit Switch Trip ................................................................. 16
Rapid Advance (For Models With Firmware ID Code
“o2HC”, “o2UC”, “ouHC” and “ouUC”) ...................................... 17
How to Rapid Advance During All Steps (Except First Fill Step) .. 17
How to Rapid Advance (During First Fill Step) .............................. 17
Test Cycle ............................................................................................. 17
Permanent Diagnostic Test Cycle......................................................... 18
Cycle Charts for Domestic OPL Models Built After April 2005
(Displays P-F5) .................................................................................. 20
Cycle Charts for Domestic OPL Models Built Prior to April 2005
(Displays P-F1) .................................................................................. 23
Cycle Charts for International OPL ...................................................... 26