Using the lan mac eeprom utility – Aspire Digital 5332 User Manual
Page 55
Chapter 2
45
Using the LAN MAC EEPROM Utility
You can use the MAC.BAT utility to write the MAC.CFG file to the EEPROM under DOS mode.
1.
Use a text editor (for example: Notepad) to open the MAC.CFG file. You can see the MAC.CFG contents
as below:
2.
In DOS mode, run the MAC.BAT file to write MAC values to eeprom.
WriteData = ‘001122334455'
MAC value
StartAddr=7A
MAC address
WriteLeng=6
MAC value length
KeepByte=0
don’t care
This manual is related to the following products: