AT&T 1412 - Manual (Page 6)

Before You Install
1 Choose a location for the base near an electrical outlet
and a telephone jack.
This phone requires a modular telephone jack and a standard
electrical outlet (110v AC) not controlled by a wall switch.
¥
NOTE: Install the base unit away from electronic equipment,
such as personal computers, television sets or microwave ovens.
Avoid excessive heat, cold, dust or moisture.
2 Install the handset battery.
Use only AT&T Battery 3301:SKU #91076.
3
INSTALLATION
d) Replace
cover by
sliding it up
into place.
a) Remove battery
compartment
cover by
pressing on
the indentation
and sliding
downward.
c ) Place battery pack in
c o m p a rtment with the
w i res in the lower left
c o rn e r, along the
bottom of the battery
p a ck .
b) Align two
holes in plug
with socke t
p i n s , and snap
the plug into
p l a c e .
1412 2002.12.7 9:20 AM Page 3