beautypg.com

Troubleshooting, 7rslf 3rvvleoh &dxvh 6roxwlrq, Operation – Amana ACS3350 User Manual

Page 26

background image

26

Troubleshooting

You may save time and money by checking items below before calling for service. List includes common concerns

that are not the result of defective workmanship or materials. If your question is not explained below, contact Amana

Consumer Affairs Department at 800-843-0304.

7RSLF

3RVVLEOH &DXVH

6ROXWLRQ

OPERATION

Appliance not working

Power outage

Oven door locked

Make sure appliance is plugged in.
Verify that circuit breaker is not tripped.
Replace household fuse but do not change fuse capacity.

Allow oven to cool for automatic lock to disengage. Once
oven has unlocked, set oven to desired temperature.

Self clean shuts off during cycle

Using surface burners during
self clean cycle

Surface burners should not be used during a self clean
cycle. Set self clean cycle to delay when range does not
need to be used.

Surface burner does not ignite

Poor cap placement

Dirt or debris on electrode

Turn control to OFF and follow directions in Placing
Burner Cap
section.

Turn control to OFF and folow directions in Care and
Cleaning
section.

Broil cycle stops

Oven door open

Oven door must be closed during a broil cycle. Close
oven door and broil cycle should resume normally.

Clock and timer not working

Power outage

Make sure appliance is plugged in. Verify that circuit
breaker is not tripped. Replace fuse but do not change
fuse capacity.

Oven light not working

Loose bulb
Burnt out bulb

Check for loose bulb. Tighten.
Check for burnt out bulb. Replace if necessary with an
appliance bulb.

Oven door will not unlock

Oven is self-cleaning

Oven still hot

Allow cycle to complete or cancel function.

Will not unlatch until a certain cooler temperature has
been reached. Do not force door open—will void
warranty. May blow cooler air on latch with hair dryer at
cool setting to quicken process.

Oven not clean after a self clean cycle

Too much soil, grime left in
oven

Soot remains in oven after
cycle

Wipe out and remove excess soil prior to running
self-clean cycle.

Normal. Wipe out with damp cloth.

Pans rock on surface burner grates

Warped pans

See Utensil section to check pan for flat bottom.

Locked light displayed

Door locked

If oven is hot, allow to cool rather than trying to force door
open.

Display flashing

Power failure reset clock

Press CLOCK.

F-(numeric) display

Service code

Shut off power to oven for three minutes by switching off
circuit breaker. Reset breaker. If continues, contact
service department.

Oven smokes the first few times used

Normal

Minor smoking is normal the first few times the oven is
used.

This manual is related to the following products: