Amana ACS3350 - Manual (Page 11)

11
Child lockout
This safety feature is used to prevent children from accidentally
programming oven by disabling electronic oven control. Child lockout is also
useful to prevent accidental programming while cleaning the range control.
Press and hold the BAKE and CLOCK pads for 5 seconds. OFF displays
where the temperature normally appears. To reactivate control, press and
hold the BAKE and CLOCK pads for 5 seconds on the oven control. Child
lockout must be reset after a power failure.
12-hour automatic cancel
This safety feature prevents oven from continuing to operate if it has been
left on for over 12 hours. If a cooking function continues longer than 12
hours without any options on oven control being touched, this feature turns
oven off. Any time an option is touched, 12-hour automatic cancel is reset.
Features
Oven temperature control adjustment
Your range is calibrated at the factory for proper temperature. Due to
individual variances and preferences, it may be necessary to adjust ovens
once they have been installed.
When first using the oven, follow recipe times and temperatures. Before
adjusting oven baking temperature, test a recipe by setting oven
temperature higher or lower than the suggested temperature. The baking
results should help you to decide how much of a temperature adjustment is
required.
An accurate digital thermometer is necessary to calibrate the oven. Store
purchased oven thermometers may not accurately measure oven
temperature. Oven temperature can be increased or decreased by 35°F. To
avoid over adjusting the oven, only adjust the temperature by 5°F each time.
NOTE: DO NOT place aluminum foil on racks and oven bottom as this
will alter oven performance. Check for blocked heat vents. If it
still appears the oven is not performing as expected, a
calibration may be done.
1. Press BAKE pad.
2. Using the UP arrow pad until an oven temperature greater than 500°F
displays.
3. Immediately press and hold BAKE pad for approximately 5 seconds.
4. A double digit offset temperature will display. Factory default is normally
00 degrees.
• Use arrow pads to key to adjust the temperature change in 5°
increments.
• When temperature is adjusted to a cooler setting, a minus sign (-) will
display with the offset temperature.
5. To set the temperature change, press OVEN CANCEL pad.
• Offset temperature change will be retained through a power failure.
Service codes and tones
Electronic oven control is equipped with a self-diagnostic system.
The self-diagnostic system alerts you if there is an error or problem with the
unit. If electronic range control sounds a series of short, rapid beeps for over
16 seconds and display shows an F-code, record the F-code shown. Some
F-codes can be cleared by pressing cancel or disconnecting power to the
range for at least 3 minutes. If the code continues to reoccur disconnect
electrical supply to range and contact an authorized servicer.
F -
co de P o ssib le M ean in g
F 1 S horted pad button
F 2 O ven over tem perature
F 3 O pen circuit in oven
F 4 S horted circuit in oven
F 5 F ailed circuit in control
F 7 Lock failure
F 9 Lock failure