Amphion M510 - Manual (Page 26)

25
Audio Setup Page
Priority
Audio setup options should only be changed
if the DVD player is connected to a LEFT or
RIGHT surround sound processor.
Speaker Setup
Changing setup values (continued)
Post Drc:
This is selected to adjust post dynamic range
compression function to obtain the different
compression results.
Downmix:
Switches the mixing down methods wh en yo u pla y a
DVD with rear signal components. This function
can be set to "LT/RT", "Stereo", "V SURR ".
CHAPTER
6
INITIAL
SETTINGS
SPDIF Setup
Speaker Setup
SPDIF Setup
SPDIF OUTPUT :
Press" / " to select "SPDIF Output" .
CD:
DOLBY DIGITAL :
DTS :
MPEG:
PCM Channel:
Press" / " to select "CD" digital output while
"SPDIF Output" is set to "Manual".
Press" / " to select "Dolby digital" output
while "SPDIF Output" is set to "Manual".
Press" / " to select "DTS" digital output while
"SPDIF Output" is set to "Manual".
Press" / " to select "MPEG" digital output
while "SPDIF Output" is set to "Manual".
Press" / " to select "PCM" channel digital
output while "SPDIF Output" is set to "Manual".
LPCM Out:
Press" / " to select "LPCM Out" frequency.
2 channel 48k and 96K.
Dolby Digital Setup
DUAL MONO :
This is the output mode of the L and R signals of
the set audio output. If it is set to "Mix-Mono", this
function only works when the DVD is being played
in 2 channel.
Dynamic:
Press" / " to adjust the linear compression rate
of the signal.
Dolby Digital Setup