AEG 88840 - Manual (Page 19)

1. Select the programme and additional functions/options if necessary.
2. Press the DELAY button as many times as necessary.
During selection, END TIME of the cycle increases in the display and delay icon is
on.
If you reach 20 hours of start delay and you press the button again, the time delay
is cancelled and delay icon disappears.
3. To activate the delay timer, press the START PAUSE button. The amount of time re-
maining until the programme is set to start is continuously displayed (e.g. 5:00 hours,
4:59… 0:30 minutes etc).
The message Delay Start and delay icon is on.
Starting the ProSteam programme
Press the START PAUSE button. The programme
starts.
The progress bar and the name of currently per-
formed phase, above it, show stage of the cycle.
With wet laundry, after a few minutes the appli-
ance will show the correct programme duration
for the ProSteam programme including the pre-
ceding drying programme.
As soon as the right level of dryness is reached, the ProSteam programme will start auto-
matically. Alternately Steam Treatment and Steam Injection phases names are displayed.
During the steam phases that form part of the ProSteam programme and also the
anti-crease phase the loading door cannot be opened.
Risk of burns!
If the steam water tank is empty when you select
a ProSteam programme the following message
will appear on the display (see picture). The pro-
gramme cannot be started. You will need to fill
the water tank first (see chapter ProSteam sys-
tem- section Filling steam water tank)
It is normal for the appliance to make noises during a ProSteam or drying programme if
garments with hard parts, such as metal buttons, are put in the drum.
Changing a programme
To change a programme which has been selected by mistake once the programme has
started, first turn the programme selector to OFF and then reset the programme.
The programme can no longer be changed directly once the programme has started.
If you nevertheless attempt to change the programme with the programme knob
the following message is shown:
Please turn programme selector to the last used position.
The drying programme is not however affected by this.
COTTON SHIRTS 0:21
13:22
--- MED ---
Press START to run
programme.
The steam water tank is empty. Please fill
it and then press START.
ProSteam system 19