Lenovo B460 Notebook - Manual (Page 40)

36
Appendix A. CRU instructions
6 If two SO-DIMMs are already installed in the memory slot, remove one of
them to make room for the new one by pressing out on the latches on
both edges of the socket at the same time. Be sure to save the old SO-
DIMM for future use.
7 Insert the notched end of the DIMM into the socket.
Press the DIMM firmly, and pivot it until it snaps into place. Make sure
that it is firmly fixed in the slot and does not move easily.
8 After aligning the attachment clips with their matching gaps, reinstall the
compartment cover.
9 Tighten the screws.
0 Reinstall the battery.
A Turn the computer over again. Connect the AC adapter and the cables to
the computer again.
Note: If only one DIMM is used on the computer you are servicing, the card must be installed
in SLOT-0 ( : lower slot), but not in SLOT-1 ( : upper slot).
b
a a
b
a
B460 User Guide V1.0_en.book Page 36 Thursday, March 25, 2010 2:06 PM