beautypg.com

Lenovo K2450 Notebook User Manual

Page 12

background image

x

User Guide

Electrical current safety information

DANGER

DANGER

Liquid crystal display (LCD) notice

CAUTION:
For products with mercury-containing fluorescent lamps (for example, non-LED)

The fluorescent lamp in the liquid crystal display contains mercury; dispose of according to local,
state, or federal laws.

The LCD is made of glass, and rough handling or dropping the computer can cause the LCD to
break. If the LCD breaks and the internal fluid gets into your eyes or on your hands, immediately
wash the affected areas with water for at least 15 minutes; if any symptoms are present after
washing, get medical care.

Electric current from power, telephone, and communication cables is hazardous.

To avoid a shock hazard:

Do not use your computer during a lightning storm.

Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration
of this product during an electrical storm.

Connect all power cords to a properly wired and grounded electrical outlet.

Connect to properly wired outlets any equipment that will be attached to this product.

Whenever possible, use one hand only to connect or disconnect signal cables.

Never turn on any equipment when there is evidence of fire, water, or structural damage.

Disconnect the attached power cords, battery pack, and all the cables before you open the device
covers, unless instructed otherwise in the installation and configuration procedures.

Do not use your computer until all internal parts enclosures are fastened into place. Never use the
computer when internal parts and circuits are exposed.

Connect and disconnect cables as described in the following procedures when installing, moving, or
opening covers on this product or attached devices.

To connect:

1. Turn everything OFF.

2. First, attach all cables to devices.

3. Attach signal cables to connectors.

4. Attach power cords to outlets.

5. Turn devices ON.

To disconnect:

1. Turn everything OFF.

2. First, remove power cords from outlets.

3. Remove signal cables from connectors.

4. Remove all cables from devices.

The power cord must be disconnected from the wall outlet or receptacle before installing all other
electrical cables connected to the computer.

The power cord may be reconnected to the wall outlet or receptacle only after all other electrical
cables have been connected to the computer.