Alarm indicators – Auto Page RF-225 User Manual
Page 6
6
ALARM INDICATORS
(OPTIONAL) If alarm options are installed.
CHIRP INDICATORS: PARKING LIGHTS:
Chirp
Function
Parking Light
Function
1 chirp
Arm
1 flash
Arm
2 chirps
Disarm
2 flashes
Disarm
3 chirps
Defective
reminder
3 flashes
Disarm/
Intrusion
4 chirps
6 chirp
Disarm/
Intrusion
Car
Locator
12 flashes Car Locator
LED INDICATORS:
LED
Function
LED
Function
Off
Disarmed
2
flashes...
pause
Trigger on trunk/hood
Slow
flash
Armed
3
flashes...
pause
Trigger on door switch
Fast
flash
Passive
arming
4
flashes...
pause
Trigger on Dual Zone
Shock Sensor
On
(solid)
Valet mode
5
flashes...
pause
Trigger on Ignition
switch
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
CHANGING THE BATTERY IN YOUR TRANSMITTERS
XT-33:
The XT-33 transmitter uses two (2) 3-volt lithium ion batteries (#CR2016) that are
sandwiched together with the (+) side facing upward. To replace the battery, you will need to
use a small flat blade screwdriver. Locate the small notch on the low er right side of the
transmitter case next to the key ring. Using the flat blade screwdriver, carefully pry the top case
from the bottom case. It should snap apart after breaking the seal. Before removing the
batteries note the direction of the positive (+) terminal. Place the new batteries in exactly the
same manner, being careful not to bend or damage the contact terminal. Snap the cases back
together and then test the transmitter to insure it arms and disarms the alarm.
(2) CR2016
3-Volt Batteries