Auto Page RF-225 - Manual (Page 3)

3
Arming feature, which allows the security system to arm 30 seconds after
the last door is closed. Operation is as follows.
1. Turn the ignition to the “OFF” position and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast
for 30 seconds. If you reopen any door / hood / trunk, the security
system LED will stop flashing. It will begin flashing again once all
vehicle entrances are closed.
3. After 30-second timer has elapsed, the security system will
automatically “ARM”. The siren or horn will chirp [1] time and the
parking lights will flash [1] time.
PASSIVE DOOR LOCKING: Programmable
The vehicle doors will automatically lock after passive arming cycle has been
completed.
ACTIVE UN-LOCKING – UNLOCK & DISARM: (OPTIONAL)
1. Press the button on the transmitter.
2. The siren or horn will chirp twice and parking lights will flash twice to
indicate that the security system is now disarmed. The vehicle doors will
unlock when interfaced with the security system.
TAMPER DISARMING: (OPTIONAL). If the alarm is triggered; Upon
disarming the system the siren or horn will chirp 4 times and parking lights
will flash 3 times. This will indicate that the alarm has been triggered while
armed.
TWO STEP DOOR UNLOCK: (OPTIONAL) This feature will independently
unlock the driver’s door only when disarming the security system. Pushing
the button on the transmitter a second time within 3 seconds will unlock
the entire vehicle. Optional
AUTOMATIC RE-LOCKING or RE-ARM: If this feature is selected, the
security system will automatically re-arm itself 60 seconds after disarming
with remote transmitter. Automatic rearm will cancel if any door is opened
before the 60 seconds timer has elapsed.
DISARMING WITHOUT A TRANSMITTER
The Override function may be used if the remote transmitter is lost or
inoperative.
1. Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm
will sound.)
2. Within 10 seconds push and release the valet switch
The alarm will stop sounding and enter the disarm mode. You can now
start and operate the vehicle normally.
VALET MODE:
The valet switch allows you to temporarily bypass all alarm functions
eliminating the need to hand your transmitter to parking attendants or
garage mechanics. When the system is in valet mode, all alarm functions
are bypassed, however, the remote panic feature and remote door locks
will remain operational.
Enter Valet Mode:
1. Turn the ignition to “ON” position.
2. Push and hold valet switch for 2 seconds or until the LED turns on.
The LED will remain on as long as the system is in 'valet mode'.
Exit Valet Mode:
1. Return to normal operation, turn ignition 'ON'.
2. Push and hold valet switch for 2 seconds; the LED will turn off
indicating the system is exiting the valet mode.