Kodak SPORT C135 - Manual (Page 48)

41 www.kodak.com/go/support
8
Using an EYE-FI Card
This chapter pertains only if you’re using an EYE-FI Card.
An Eye-Fi Card stores pictures in the same way that an SD/SDHC Card does. It also
has a built-in Wi-Fi antenna that uses your Wi-Fi network to transfer pictures from
your camera to your computer or mobile device.
IMPORTANT: Choose an EYE-FI X2 Card or higher, with a firmware version of 4.5174 or
higher. View and update firmware using the Eye-Fi Center Software that
accompanies the card.
Storing pictures on an EYE-FI Card
To set up and use the EYE-FI Card and EYE-FI Center Software, follow the EYE-FI
documentation to set up the card. For further EYE-FI support, go to
support.eye.fi .
CAUTION:
If you’re using an EYE-FI Card in this camera, it’s critical that you disable
(do not turn on) Endless Memory Mode in EYE-FI Center Software.
1 Turn off the camera, then open the door.
2 Insert a card until it clicks.
To remove a card, press and release it.
IMPORTANT: When you turn on the camera, it checks to
see if a card is inserted. If pictures/videos are
detected in internal memory, the camera
prompts you to move them to the card. New
pictures/videos are stored on the card.
Accessory
Get support for EYE-FI Cards and Software support.eye.fi