Kodak M320 User Manual
Page 48
42
www.kodak.com/go/support
Troubleshooting
Picture quality problems
Status
Solution
Picture is not clear
■
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■
Clean the lens (see
■
Make sure the camera is not in Macro mode if you are more than
27.6 in. (70 cm) from your subject.
■
Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
Picture is too dark
■
Reposition the camera for more available light.
■
Use Fill flash (see
) or change your position so light is not
behind the subject.
■
Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on
■
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
Picture is too light
■
Reposition the camera to reduce the amount of available light.
■
Turn the flash off (see
■
Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on
■
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■
In Panorama SCN mode, adjust the Exposure Compensation (