Vollrath Cayenne Cheese Melter - Manual (Page 3)

3
ENGLISH
O
peratOr
’
s
M
anual
o
peration
WARNING
Burn Hazard.
Do not touch hot food, liquid or heating surfaces
while equipment is heating or operating.
Hot surfaces and food can burn skin. Allow the hot surfaces to cool
before handling. Do not drop or spill water onto the cooking surface
as it can spray or splatter.
Before initial use, turn the temperature control to the maximum setting, and
allow equipment to burn-in for 30 minutes. You will notice odor appearing due
to the components burning-in. This is normal.
The back panel may be removed for access to both sides of the equipment
creating a “pass through”.
To adjust the leveling feet:
1. Hold the leg (F) and rotate the feet (G) so the equipment is level. See
Figure 1.
2. Place the food grid (D) into the desired height of the grid/tray support
(E). The food grid must be level and in the center groove of the grid/tray
support.
3. Grasp and slide the food grid (D) out using a tongs, gloves, mitts or pot
holders to protect hands.
4. Hold the food grid (D) and evenly load food product onto the food grid.
5. Turn the temperature control (A) to the desired number setting. Follow
food manufactures instructions for correct preparation and safe serving
guidelines.
6. Cook the food products in desired manner.
7. Grasp and slide the food grid (D) out using a tongs, gloves, mitts or pot
holders.
8. Remove the food product using tongs or other specialized utensils.
9. Slide the food grid (D) back into the equipment using a tongs, gloves,
mitts or pot holders.
c
leaning
To maintain the appearance and increase the service life, clean your
equipment daily.
NOTE:
Do not use cleaning products containing aggressive
chemicals, acids, or that contain chlorine.
WARNING
Burn Hazard.
Do not touch hot food, liquid or heating surfaces
while equipment is heating or operating.
Hot surfaces and food can burn skin. Allow the hot surfaces to cool
before handling. Do not drop or spill water into the cooking surface
as it can spray or splatter.
1. Turn off and unplug the equipment.
2. Allow the equipment to cool completely before cleaning.
WARNING
Electrical Shock Hazard.
Keep water and other liquids from entering the
inside of the equipment. Liquid inside the equipment
could cause an electrical shock.
Do not spray water or cleaning products. Liquid could contact the
electrical components and cause a short circuit or an electrical
shock. Do not use equipment if power cord is damaged or has been
modified
NOTE:
Do not immerse the cord, plug or equipment in water or
any other liquid.
3. Using a damp cloth, sponge dipped in soapy water to clean the outside
of the equipment.
4. Remove, clean and dry the food grid (D) and crumb tray (C). See
Figure 1
5. Place the food grid (D) into the desired height of the grid/tray support
(E). The food grid must be level and in the center groove of the grid/tray
support.
t
roUbleShooting
T
roubleshooTing
C
harT
Problem It might be caused by Course of Action
Pilot light does not come on when the temperature
control is turned up.
The equipment is not plugged in. Plug equipment in.
Pilot light malfunction. Replace pilot light.
Temperature control malfunction. Replace temperature control.
The pilot light comes on, equipment does not heat. Heating element malfunction. Replace heating element.