Vollrath Mirage 1800 Watt Fajita Heater Induction Ranges - Manual (Page 3)

F
ajita
S
killet
P
an
H
eater
3
ENGLISH
O
peratOr
’
s
M
anual
WARNING
Burn Hazard.
Do not touch cookware, heating surface, food, or
liquid while heating.
Hot food and liquids can burn skin. Induction heating surfaces heat
very rapidly. Use caution when adding to pre-heated oil, liquid or
other food already in the cookware.
If the temperature of the cooking surface becomes too hot, the unit will turn
off. The display will flash “F2” to indicate the unit is in “over-heating protection”
mode. After the unit has cooled, turn the cooking surface on and if “F2” is not
displayed, then cooking can resume.
The display window should remain constant during operation. If the display is
flashing, see the TROUBLESHOOTING section in this manual.
Removing cookware from the cooking surface for more than 10 seconds will
cause the unit to automatically turn off. Removing cookware for less than five
minutes will not interrupt operation of the unit.
All units will start in Power Mode when turned on first time.
B A C
Figure 1. Control Panel
A
OFF button. Press to turn unit OFF.
B
HEAT button. Press this button to activate the heating cycle. The
cookware will heat to a temperature of 450°F – 550°F or
(232°C – 278°C) in a time cycle of 120 to 140 seconds.
C
DISPLAY panel. This displays the time remaining during the heat
cycle and displays fault codes.
c
leaning
To maintain the appearance and increase the service life, clean your
induction range daily.
WARNING
Burn Hazard.
Do not touch cookware, heating surface, food, or
liquid while heating.
Hot food and liquids can burn skin. Induction heating surfaces heat
very rapidly. Allow the heating surface to cool before handling.
WARNING
Electrical Shock Hazard.
Keep water and other liquids from entering the
inside of the unit. Liquid inside the unit could cause
an electrical shock.
Do not spray water or cleaning products. Liquid could contact the
electrical components and cause a short circuit or an electrical
shock.
1. Unplug the unit and let it completely cool.
2. Wipe the unit exterior with a clean damp cloth.
3. Do not use abrasive materials, scratching cleansers or souring pad to
clean the unit. These can damage the finish.
4. Thoroughly wipe off any mild soap or chemical cleaners. Residue could
corrode the surface of the unit.