Vogels PFW 6870 - Manual (Page 7)

PFW 6870
Installation Instructions Page 7
Installalation
1) Place the mount against the wall and align it with the
pilot hole.
2) Insert one (1) 5 /
16
˝ x 3˝ lag bolt and one (1) 5 /
16
˝
washer into the upper right pilot hole.
3) Use a socket wrench and a ½˝ socket to tighten the
lag bolt.
Do not overtighten the lag bolt.
Step 4
Step 5
Step 6
1) Level the mount.
2) Use a pencil to mark the remaining four (4)
mounting locations along the center of each wall
stud.
Two people are recommended for this step; one
person to level the mount and another person to
drill the pilot holes.
Drill a “pilot hole” in the center of each of the marks with
a power drill and a ¼″ drill bit.
Only use ¼″ drill bit when drilling the pilot holes.
Step 7
1) Insert one (1) 5 /
16
″ x 3″ lag bolt and one (1) 5 /
16
″
washer into each pilot hole
2) Tighten all lag bolts using a socket wrench and ½″
socket.
Do not overtighten the lag bolts when attaching
the mount to the wall. Improper installation may
result in personal injury or property damage.
If you are using OPTIONAL model specific spacers,
proceed to the "Installing Optional Model Specific
Spacers" on page 8.
If not, proceed to “Installing the Mounting Bracket”
on page 9.