ATON DLA2RF User Manual
Start here, Connect rf receiver, Stereo receiver with "a/b
Start Here
s
Run all speaker wiring (16 gauge is recommended) to the DLA2RF.
Be sure to label the wires for easy identification.
s
Place the DLA2RF in the same equipment location as the Receiver/Amplifier.
s
Turn off all power to the Receiver/Amplifier and make sure the DLA2RF power supply is unplugged!
s
Strip approximately 3/8" of insulation from the ends of all speaker wiring.
Twist the exposed end of each speaker wire to ensure that no loose strands remain.
3/8"
Speaker Wire
3
Connect RF Receiver
Connect the RF Receiver
to the
ATON Port
RJ11
A
Stereo Receiver with "A/B"
+
+
–
To local speakers
To DLA input
–
To DLA input
+
–
+
–
To local speakers
To DLA input
–
+
–
+
+
–
+
–
1
Choose Receiver/Amplifier Type
B
Home Theater Receiver with "A/B"
2
Connect Speakers
C
Home Theater Receiver with "Zone 2"
Connect
to the
"Zone 2"
speaker
terminals.
NOTE: Refer to your receiver manual for help
activating your "Zone 2" speaker outputs.
Connect
to the "B"
speaker
terminals.
Connect
to the "B"
speaker
terminals.
Speaker Wire
Speaker Wire
Speaker Wire
Be sure to connect the positive speaker wire to the
positive input of the speaker and the negative speaker
wire to the negative input of the speaker.
Please consult your owner's manual for additional
installation examples, applications and safety instructions.
While listening to the room turned
on in the previous step, slowly adjust
the Receiver/Amplifier volume to
a level that is the loudest it can
play in the room without distortion
or clipping. Make a note of the
volume level for future reference.
ust
10
Receiver/Amplifier
Volume Knob
8
Turn on one room
from the front panel
of the DLA2RF and
adjust volume level
to maximum.
9
Set the Receiver/
Amplifier to stereo
mode and disable
any surround
sound or DSP
"Sound Fields."
7
Finally, turn on each room
from the front panel of the
DLA2RF and adjust to a
comfortable listening level.
11
Adjust the Receiver/
Amplifier
volume
to the
lowest level.
Receiver/
el.
Receiver/Amplifier
Volume Knob
6
Turn on the Receiver/
Amplifier and start
audio source (CD
player, radio, etc.).
Power
Start
Audio Source
5
Plug in the DLA2RF
Power Supply.
4
WARNING! Do not connect speakers to the DLA2RF that have an impedance value lower than what is supported
by your receiver/amplifier. In doing so, you run the risk of overheating and damaging both the DLA2RF and your
receiver/amplifier! Consult speaker and receiver/amplifier manuals for their specific impedance ratings.
If using a Receiver with "A/B" speaker outputs:
s
s
OR
NOTE: When using the "A+B" setting, the receiver volume will need to be adjusted accordingly.
When the DLA2RF is not in use, turn off the "B" speakers and turn on
the "A" speakers for normal stereo/surround sound listening.
+
–
–
+
+
–
–
+
+
–
–
+
L
R
L
R
L
R
+
+
–
–
!