TotalPond A16531L - Manual (Page 3)

3. Choose a container for your fountain kit. Fig. 3
Fig. 3
4. If the container is not already watertight, use a plastic liner. Or if a
clay pot is used, spray the inside of the pot with a clear acrylic
sealant. Be sure to use a sealant that is safe for clay pots. Wait 24
hours for the sealant to dry before filling the container with water.
Fig. 4
Fig. 4
5. Test fit the assembled container fountain kit in the container. For
installing the fountain with the pump cord over the side of the
container (recommended), proceed to step 9. For having the pump
cord comes out through the container wall, proceed to the next
step. Fig. 5
Fig. 5
6. Select a spot on the container wall that is the least visible from
normal viewing for the cord exit. Drill a hole in appropriate 1 1/4 in.
diameter. Fig. 6
NOTE: Appropriate safety equipment should be used.
Fig. 6
Liner
Cord