Silent Call SK2-SS - Manual (Page 4)

4
3. Set Clock Time: Press and release the MODE pushbutton (the large button located at the lower right
hand side on the unit). The Orange LED will light up to let you know that you are in “Set Clock
Time” mode.
4. Press and release the minute button to set the minutes. Press and release the hour button to set the
hour.
5. When you are finished setting the minutes and hours, press and release the MODE pushbutton three
times to exit the Setup Mode.
NOTE: Any time you unplug your Sidekick II Receiver from the wall outlet or turn the power off,
the next time you turn your Sidekick II Receiver on again, you will need to reset the clock. If you
are using the Battery Backup feature, you will not need to do this.
6. All of your Signature Series transmitters come pre-programmed from the factory to work with your
Sidekick II Signature Series Receiver. If you need to set your transmitters to a different address, please
refer to the section in this manual on programming transmitters. The only reason you would need
to do this is if someone in your area is using Silent Call products and they are interfering with your
products or if you want to use the Supervision Capability with your Silent Call Smoke Detectors or
Fire Transmitters.
Setting Alarm Clock:
1. Press and release the MODE push button twice.
2. The Green LED will light up indicating that you are in the “SET UP” mode. The display will show the
present Alarm Clock Time setting.
3. Press and release the MINUTES button to set minutes and press and release the HOURS button to set
the hours.
4. Once the Alarm Clock Time has been set, press the MODE button 2 times to exit the “SET UP”
mode.
5. When your alarm is activated the strobe light and bell icon will flash and the bed vibrator (optional)
will shake.
6. To turn the ALARM on or off, press and release the “Alarm Clock” button. When the alarm is turned
ON the BELL ICON will appear on the screen.