Arcam P1000 - Manual (Page 11)

P1000
E-10
E
n
g
li
s
h
P1000
E-11
Technical specification
All measurements are with 230V/50Hz mains power
Continuous output power
All channels driven, 20Hz—20kHz, 8Ω 135W per channel; 945W total
All channels driven, 20Hz—20kHz, 4Ω 210W per channel; 1.47kW total
One or two channels driven at 1kHz, 8Ω 190W per channel
One or two channels driven at 1kHz, 4Ω 305W per channel
One or two channels driven at 1kHz, 3.2Ω 325W per channel
Peak output current capability
±20.5A per channel
Total harmonic distortion
At any level up to rated power, into 4 or 8Ω <0.08% maximum (20Hz—20kHz); typically
<0.007% at 1kHz
Frequency response
±0.2dB (2Hz—50kHz)
–1dB at 1Hz and 100kHz
Residual hum and noise
Ref. full power –110dB A weighted, or 100dB CCIR
Voltage gain
User selectable:
A: x31.5dB
B: x29dB
C: x26dB
Input impedance
22kΩ in parallel with 180pF
Output impedance
20mΩ at 20Hz, 1kHz
80mΩ at 20kHz
Power requirements
115V or 230VAC, 50/60Hz, 2.2kW maximum via IEC
mains inlet.
A zero-crossing AC system eliminates large
‘transformer’ in-rush currents at switch on.
Physical
Dimensions: W430 x D400 x H133 mm
Mass: 18kg (40 lb) net; 21kg (46 lb) packed
E&OE
Continual improvement policy
Arcam has a policy of continual improvement for its products. This means that designs and specifications
are subject to change without notice.
All specification values are typical unless otherwise stated.
Radio interference
The P1000 is an audio device which has been designed to very high standards of electromagnetic
compatibility.
The unit can radiate RF (radio frequency) energy. In some cases this can cause interference with FM and
AM radio reception. If this is the case, keep the P1000 and its connecting cables as far from the tuner and
its aerials as possible. Connecting the P1000 and the tuner to different mains sockets can also help to
reduce interference.
EC Countries – These products have been designed to comply with directive 89/336/EEC.
USA – These products comply with FCC requirements.