Recora COS Chair Occupancy Sensors - Manual (Page 4)

When placing the sensor be sure to have the
wire exit the bed opposite the patient bed exit.
Shown in this photo is the WRONG orientation
for the bed sensor. Having the wire exit directly
under a person’s feet will encourage tripping
and potential premature failure of the sensor due
to accidental pulls on the wire.
NEVER remove the sensor from the bed or chair by
pulling on the wire. The wire can pull out of the sensor.
This breaks the sensor and cannot be restored.
Shown here is the correct way
to remove the BOS from the
bed. Grasp the sensor carrier
and remove the sensor
without pulling on the wire.