Nostalgia Electrics RRF300SDD SERIES - Manual (Page 12)

E
N
G
LI
S
H
10
HOW TO OPERATE
Before first use, remove all adhesive tape from the
drawers, shelves, trays and drain tube plug.
INSTALLATION
1. The refrigerator should be placed on a completely flat surface. Allow 1 foot of space
on each side of the refrigerator and between the refrigerator and the wall. Also allow
at least 8 inches of space between the top of the refrigerator and the ceiling.
2. Choose a location for your refrigerator that is not exposed to sunlight, high
temperature or humidity, as humidity may stain and damage the refrigerator.
3. The appliance can be adjusted by rolling the two legs in the bottom front of the refrigerator
if it becomes unstable. Raise the refrigerator by rolling the two legs clockwise.
4. The surface of the location where the refrigerator is installed should be firm
and flat. If refrigerator is not secured in a proper location, noise and vibration
may occur. The noise may be increased if the floor is not firm. If you have
to position the refrigerator on a carpeted floor, place a sheet underneath
the refrigerator to prevent heat emissions from ruining the carpet.
5. Make sure that legs are pressed firmly into the floor and allow the refrigerator
to lean backward slightly so that the doors remain closed.
PLACEMENT OF FOOD
1. There should always be some space between items inside for air circulation.
2. Food should be kept in sealed containers to avoid becoming
dry, spoiled or creating odors in the refrigerator.
3. Hot food should be cooled down before placing into the
appliance. Otherwise, bacteria will grow in food.
4. Reducing the frequency of opening the doors can lower the electricity consumption.
NOTE: Do not use any electronic equipment inside the appliance.
ADJUSTING TEMPERATURE
The temperature of the refrigerator can be controlled manually by the thermostat
control dial. However, the number shown on the dial does not correlate to the degrees.
The higher the number, the lower the interior temperature of the refrigerator will be.
0 = OFF 1= Higher Temperature (warmer)
4 = Normal Use 7 = Lower Temperature (colder)
PACKING AND MOVING
Save packing materials if possible and remember how materials are
packed in the box. Repack refrigerator and accessories carefully.
DO NOT lift or pull the doors or door handles during transportation.
When moving, do not tilt appliance more than 45 degrees. Be
very careful not to bump the refrigerator into anything.