Nostalgia Electrics RRF300SDD SERIES - Manual (Page 11)

E
N
G
LI
S
H
9
5. Install the tap cover by leveling its hooks at the three square holes in
the door, then fasten the cover on the door with one #2 screw.
INSTALLING THE WATER DISPENSER
1. Line up the tank drainage hole with
the upper door bar of the refrigerator.
3. Attach the tap-adapting
tube to the door with nut (#5).
6. Fasten the protective pipe cover
to the door with one #2 screw.
7. Fill tank with your beverage of choice
and secure the cap on the top.
4. Attach two clamps (#6) to
connecting pipe, then connect
tap-adapting tube to door bar
drainage hold and secure clamps.
2. Insert tap-adapting tube through
the outer door sleeve.