Nostalgia Electrics KRS6100 SERIES - Manual (Page 17)

E
N
G
LI
S
H
15
CLEANING & MAINTENANCE
Follow the steps below to clean the Beer Tap and Hoses. (see illustration)
1. Turn off CO2 completely before
attempting to clean.
2. Remove the hose from the Keg
Coupler and carefully twist the
dispenser faucet off the top of
the DOUBLE KEGORATOR™.
3. Ensure that the dispenser handle
is in the down position before
flushing the hose. If this is not
set correctly, water cannot flow
through. Hold the open end of the
hose under running water for 3-5
minutes, while the Beer Dispenser
Faucet drains into the sink. This will clear any excess beer that is trapped inside,
helping to prevent any bacteria or mold that could accumulate inside.
4. In order to clean and remove any excess beer that may leak into the unit space inside
the door, remove the black rubber insulation and wipe with a wet towel as needed.
Follow the guidelines below to care for your DOUBLE KEGORATOR™ when not in use.
• Please adjust the temperature gauge to MIN in colder environments
because this unit does not self-defrost and ice may build up inside the
unit. The temperature gauge is located on the back side of the DOUBLE
KEGORATOR™ inside the cut out area at the bottom to the lower left.
• Always rinse the beer line if you do not intend to use your DOUBLE KEGORATOR™
for a period of time. First, turn off the CO2 and dispense beer until it stops. This will
release pressure in the Beer Keg so that the Keg Coupler can safely be detached.
• To avoid permanent damage to the unit, never use sharp objects inside the DOUBLE
KEGORATOR™.
Flush hose with water 2
Detach beer line 1