Tap tower installation, En g li s h – Nostalgia Electrics KRS6100 SERIES User Manual

Page 12

& TAP TOWER INSTALLATION

You must read and understand the steps below for the CO2 assembly before installation.

When you purchase the first keg of beer, you must also have your CO2 cylinder filled at

your local supplier. CO2 tanks can be refilled at locations such as welding supply shops,

party stores, or wherever kegs are purchased.

(cont. on next page)

STEP 1

Make sure white nylon High Pressure

Washer (already installed) is attached

to CO2 Double Regulator.

STEP 2

Use Wrench to attach Double

Regulator to CO2 Tank connector.

STEP 3

Remove springs from inside the Keg Couplers.

If springs are not present, go on to Step 4.

NOTE: When using ¼ Barrel or ½ Barrel,

only one coupler needs to be used.

STEP 4

Make sure Backflow Stoppers are inserted

into the Keg Couplers (the Backflow

Stoppers go in with rounded side down).

STEP 5

After the Backflow Stoppers have

been inserted, remove the three parts

above from each Keg Coupler.