Handset installation – AT&T Trimline 205 User Manual

Page 14

Text mode
Original mode

Handset installation

1. Plug the handset cord into the jack on the lower side of the telephone

base.

2. Plug the other end of the cord into the handset and put the handset on

the telephone base.

3. Lift the handset and listen for

a dial tone. If there is no dial
tone, see

In case of difficulty

(page 15).

NOTES:

• You can make and answer

calls as soon as the
telephone is connected to
a telephone jack.

• If the handset tab on the

telephone base is not
reversed, the handset will
not stay in the telephone
base when mounted on
a wall. If you later move
this telephone to a table
or desk, be sure to reverse
the handset tab again.