MSI PROBOX23 User Manual

Page 13



Hard Disk Drive (HDD)

Step 1. Locate the HDD holder.

Step 2. Take out and press the
four plastic spacers from the
bigger hole on the holder to the
smaller fixing hole.

Step 3. Slide the HDD drive into the correct position on the holder and then fix the
screws with a screwdriver.

Step 4. Connect the SATA power
cord and SATA signal cable to the
board and the HDD drive.

Note 1: If you received a 1to2
SATA power cable, connect the
middle end to the SATA power
connector on the motherboard.

Note 2: Follow the above
procedures to install another HDD
if necessary.