MSI X99S SLI PLUS Manual - Manual (Page 102)

Appendix B
B-8 Intel RAID
■ Reset Disks to Non-RAID
Select option 3 Reset Disks to Non-RAID and press to delete the RAID
volume and remove any RAID structures from the drives. The following screen
appears:
DISK / VOLUME INFORMATION [ ]
4. Recovery Volume Options
4. Recovery Volume Options
5. Exit
RAID Volumes :
None defined.
Physical Devices :
Port Device Model Serial # Size Type/Status (Vol ID)
1 XXXX-XXXXXXXX XXXXXXXXXXXXXX XXX.XGB Non-RAID Disk
2 XXXX-XXXXXXXX XXXXXXXXXXXXXX XXX.XGB Non-RAID Disk
[ ↑↓] - Select [ESC] - Exit [ENTER] - Select Menu
1. Create RAID Volume
2. Delete RAID Volume
Resetting RAID disk will remove its RAID structures
and revert it to a non-RAID disk.
[ ] RESET RAID DATA
WARNING : Resetting a disk causes all data on the disk to be lost.
(This does not apply to Recovery volumes)
Select the disks that should be reset.
[ ↑↓] - Previous/ Next [SPACE] - Selects [ENTER] - Selection Complete
Port Drive Model Serial # Size Status
1 XXXX-XXXXXXXX XXXXXXXXXXXXXX XXX.XGB Member Disk
2 XXXX-XXXXXXXX XXXXXXXXXXXXXX XXX.XGB Member Disk
[ ] MAIN MENU
Use the key to select the disks and press key. A confirmation
sentence will appear below, and then press key to accept the selection.
Important
• You will lose all data on the RAID drives and any internal RAID structures when you
perform this operation.
• Possible reasons to “Reset Disks to Non-RAID” could include issues such as
incompatible RAID configurations or a failed volume or failed disk.