Countryman ISOMAX 4RF Desk Mount - Manual

ISOMAX 4RF Mount (A4CDM) Installation Guide
Because of the Countryman ISOMAX 4RF’s Active Vibration Isolation technology, the ISOMAX 4RF does not require a bulky
shock mount to protect against handling and table noise. The A4CDM is our simple, low-profile mount for desks or podiums.
The A4CDM mounts with a single hole; these instructions will help you securely install the A4CDM in a matter of minutes.
1. Plan Your Installation
The diagram to the left shows a typical podium installation:
• A cable runs from the mix board in the control room to a panel in the floor
near the podium (1).
• The male side of a short XLR cable (2) runs from the floor panel through the
nut (3), then through a 7/16” hole in the top of the podium (4), then through
the lower half of the A4CDM (5), and finally the wires are soldered into the
upper half of the A4CDM mount (6).
• The lower half of the A4CDM screws on to the upper half of the A4CDM.
• The nut screws on to the lower half of the A4CDM, clamping the A4CDM
firmly in place.
2. Prepare your tools
You will need:
• An XLR cable long enough to reach the mix board or nearest audio port.
• A soldering iron and soldering supplies.
• Wire strippers / cutters
• A 9/16” or adjustable wrench
• A drill and a 7/16” drill bit.
• Electrical tape OR heat shrink and a heat gun or torch.
You may also want to have:
• A multimeter to test for shorts or breaks in your wire and solder joints.
• Pliers, tweezers, or other tools to aid in soldering
Countryman Associates, Inc. 195 Constitution Drive, Menlo Park, CA 94025
Phone: (800) 669-1422 or (650) 364-9988 Fax: (650) 364-2794 Email: [email protected] Web: www.countryman.com
XLR cable
wire cutters and strippers
drill and 7/16” drill bit
(optional) multimeter
soldering iron and supplies
9/16” or adjustable wrench
electrical tape or heat shrink
(optional) tweezers/pliers
TO MIX BOARD
1
2
3
5
4
6